AMD Hackintosh Panic Near [PCI Configuration Begin] with OpenCore, macOS 10.14

Hi all! As the title states, I'm booting OpenCore 0.5.3 (DEBUG, with screen/file logging) from a USB drive on my AMD system: X470 AORUS Gaming 5 WIFI (MoBo), Ryzen 2700X, GTX 1080 (no acceleration, obviously). I already have a Mojave partition from my previous Clover setup, which I am attempting to boot.

After a lot of configuration, I finally got past the OpenCore boot screen (by adding NullCPUPowerManagement), but not much farther into the Darwin bootstrapper. My system consistently panics either directly before or after the "[PCI Configuration Begin]" statement is printed -- usually before. The backtrace, as far as I can tell, provides little useful information as to the underlying cause.

I am aware of adding npci=0x2000 (or npci=0x3000) to my OpenCore boot arguments, and neither have resulted in any change in console output. After some digging through my old Clover config.plist, I determined I had been using the AppleRTC fix, and thus applied the OpenCore AppleRTC kernel patch -- I have not noticed any difference, either. I have also attempted creating a custom "SSDT-HPET" using corpnewt's SSDTTime, but no luck.

I am using the following kexts (in order of load priority):

• Lilu.kext

• VirtualSMC.kext

• NullCPUPowerManagement.kext

• WhateverGreen.kext

• AppleALC.kext

• SmallTreeIntel82576.kext (WiFi)

I am using the following drivers (in order of load priority):

• HfsPlus.efi

• ApfsDriverLoader.efi

• FwRuntimeServices.efi

• VirtualSmc.efi

My config.plist for OpenCore can be downloaded here.

Any suggestions are greatly appreciated. Thanks!