Hello all. I have a MPB 9,2 on which I'm trying to use OpenCore to install a recent macOS version, but I've been having a lot of trouble for some reason. I have tried three different flash drives and Sequoia, Sonoma, and Ventura. I've tried each installer multiple times each. I'm following OpenCore's instructions to the letter. The first time I tried to install on top of an existing (Success' href='/2020/12/install-macos-catalina-on-supported-pc.html'>Catalina) installation out of laziness to re-configure everything, but all subsequent times I've reformatted the hard drive prior to trying the install. Each time I try it, the installer goes for a while, reboots itself once, and then shows a generic error message saying that a problem occurred during the installation. It has renamed the entire hard drive "Macintosh HD - Data" and then apparently lost track of what it was supposed to do. At this point I'm not sure where the error could be coming from - I've tried building these installers using OpenCore on two different machines, carefully selecting the correct target model each time, and since I've also tried different flash drives and OS versions the only common denominator now is the destination laptop itself, but since the hard drive is a blank slate I'm struggling to figure out what could be causing the problem there. Anyone have any suggestions?
Post a Comment