Troubleshooting NVMe Drive Detection Issue in macOS Big Sur on HP Pavilion x360


Introduction: Welcome to the troubleshooting guide for resolving NVMe drive detection issues in macOS Big Sur on the HP Pavilion x360. If you're encountering problems with your Lexar NM610pro NVMe drive not showing up in Disk Utility during macOS installation, this guide will help you identify and address the issue.

Step 1: Verify Hardware Compatibility

  • Ensure that the Lexar NM610pro NVMe drive is compatible with macOS Big Sur and Hackintosh setups.
  • Check online forums, compatibility lists, and community resources to confirm support for your specific NVMe drive model.

Step 2: Review EFI Folder Configuration

  • Download and review your EFI folder to ensure that it contains the necessary drivers, kexts, and configurations for NVMe drive support.
  • Check for any missing or outdated files that may be preventing proper detection of the NVMe drive.

Step 3: EFI Configuration Check

  • Open your EFI folder and navigate to the Clover or OpenCore configuration files.
  • Verify that the NVMe driver (such as NVMeGeneric.kext for OpenCore or NVMeDxe.efi for Clover) is properly configured and enabled.

Step 4: NVMe Drive Initialization

  • Boot into macOS installer and access Disk Utility.
  • Check if the NVMe drive is detected under the list of available drives. If not, try rescanning for drives or restarting the system to see if it appears.

Step 5: BIOS/UEFI Settings

  • Access your laptop's BIOS/UEFI settings and check for any options related to NVMe drive detection or compatibility.
  • Ensure that NVMe support is enabled and that the drive is recognized by the system.

Step 6: Hardware Troubleshooting

  • If the NVMe drive is still not detected, try reseating the drive or testing it on another system to rule out any hardware issues.
  • Consider updating your laptop's firmware or BIOS to the latest version to improve NVMe compatibility.

Step 7: Community Support

  • Seek assistance from online forums, Hackintosh communities, or Reddit groups specializing in Hackintosh setups and macOS installation on HP Pavilion x360 laptops.
  • Provide detailed information about your setup and the steps you've taken to troubleshoot the issue for more accurate assistance.

Conclusion: By following these troubleshooting steps and seeking support from the Hackintosh community, you can diagnose and resolve NVMe drive detection issues in macOS Big Sur on your HP Pavilion x360 laptop. Good luck with your Hackintosh setup!

(Note: Always ensure that you're compliant with Apple's terms of service and licensing agreements when creating a Hackintosh.)

NVME Problem in Big Sur

I'm trying to run macOS Big Sur on my HP Pavilion x360 14 cd0601ng (It's my first time doing this). Everything worked fine until I tried to install macOS after entering Disk Utility I looked for my lexar nm610pro NVMe drive just to find out it's not showing up in Disk Utility. So my question is the Lexar nm610pro not supported or am I missing any file in my EFI folder. Here is the Link for my EFI Folder: . Can someone please help me.

  • CPU: Intel i3 8130u
  • GPU: Intel UHD 620
  • RAM: 4gb 2400mhz
  • SSD: Lexar NM610pro 500gb
  • Model: HP Pavilion x360 14 cd0601ng
submitted by /u/Jas9a
[link] [comments]