Hi Everyone, I just found out last week that you could do a OS X install on a ryzen machine, I had no idea as I hadn’t even considered doing a hackintosh in nearly 5 years. Needless to say I was quite excited. I followed the vanilla hackintosh guide on amd-osx.com. Now I got past downloading OS X with git Mac OS and I created a clover partition on my usb. I added my kexts and restarted so I could boot off of my usb and install OS X. It seemed to be going well and I got to the disk utility page where I was going to reformat my drive so I can proceed with the install but about 30 seconds into navigating the disk utility my cursor froze, no key board input, and noting was loading or moving, just totally frozen. So I rebooted and tried again. After about a minute the same thing happened, everything just froze. I thought it could be my usb drivers so I tried usb 2.0. Didn’t work. I went back to windows to make sure I wasn’t missing any kext files. Still froze after a minute. Then I tried a new mouse, worked for a minute but froze shortly after I got to the disk utility page. Like I said I’m totally new at this so it’s most likely my fault. I just can’t figure out the issue. Any advice is appreciated, thanks.
Here’s my built: Ryzen 7 2700x Aorus B450m 16gb ddr4 Gtx 1060 6gb 256gb nvme for Windows 120gb ssd for OSX.
[link] [comments]
Post a Comment