Hey guys I'm really at a loss here. I can't seem to make a drive that actually shows up on my computer. I've made two boot drives so far, one with mojave and one with sierra. I assume I have the procedures right as I'm following the vanilla guide. I also tried the the net install sticky, a bit more luck but still nothing.
So here's what I do, I install the image as usual via terminal, then go to install clover. I keep getting a message both with mojave and sierra that the version of osx isn't supported, I just install anyway. I'm under the impression that this should be enough to at least have a drive that you computer can see and at least be able to get into clover (assuming bios settings are correct). Well UEFI doesn't show up soooo there's nothing to boot into.
I did however get into clover with the net installer but alas it doesn't actually show any image to boot from :/ I assume that I was able to get into clover because this method involves creating a separate partition for clover.
Not really sure what to do at this point. Any help is much appreciated.
[link] [comments]
Post a Comment