Failure as phase 1 of OS install

Hi folks. I’m a noob to hackintoshing. I have been digesting as much of Tonymacx86 as possible. I decided to build a ‘tosh from an intel NUC 7i7DNHE.

I found the guides for both clover and this build and triple checked my USB drive build, however, I am running into a very early problem; the drive boots in clover, and I can get to utilities. The SSD is formatted correctly, but when I continue to initial instal, I get to about 2% remaining, the fan speeds up, the the unit reboots.

I have tried some variation of drivers, and I have the specific kexts that are called out for this specific build, but the result is always identical.

Help! 😊

submitted by /u/ptraugot
[link] [comments]